1 files changed, 34 insertions, 0 deletions
diff --git a/conf.h b/conf.h
new file mode 100755
index 0000000..c63df84
--- /dev/null
+++ b/conf.h
@@ -0,0 +1,34 @@
+#include <xc.h>
+
+// BEGIN CONFIG
+#pragma config FOSC = HS // Oscillator Selection bits (HS oscillator)
+#pragma config WDTE = OFF // Watchdog Timer Enable bit (WDT enabled)
+#pragma config PWRTE = ON // Power-up Timer Enable bit (PWRT disabled)
+#pragma config BOREN = ON // Brown-out Reset Enable bit (BOR enabled)
+#pragma config LVP = OFF // Low-Voltage (Single-Supply) In-Circuit Serial Programming Enable bit (RB3 is digital I/O, HV on MCLR must be used for programming)
+#pragma config CPD = OFF // Data EEPROM Memory Code Protection bit (Data EEPROM code protection off)
+#pragma config WRT = OFF // Flash Program Memory Write Enable bits (Write protection off; all program memory may be written to by EECON control)
+#pragma config CP = OFF // Flash Program Memory Code Protection bit (Code protection off)
+// END CONFIG
+
+// Use internal crystal at 8MHz
+#define _XTAL_FREQ 20000000
+
+// Define baud rate of 9600
+#define Baud_rate 9600
+
+// HD44780
+#define RS RD2  // Register Select on RD2
+#define EN RD3  // Enable on RD3
+#define D4 RD4  // Data 4 on RD4
+#define D5 RD5  // Data 5 on RD5
+#define D6 RD6  // Data 6 on RD6
+#define D7 RD7  // Data 7 on RD7
+
+//Define Buttons
+#define SETB RE0
+#define DECR RE1
+#define INCR RE2
+
+//Define Buzz
+#define BEEP RD1
+\ No newline at end of file