This section only applies if you're going to configure a network card. If you don't have any network cards, you are most likely not going to create any configuration files relating to network cards. If that is the case, you must remove the network symlinks from all the runlevel directories (/etc/rc.d/rc*.d) If you're on a network you may need to set up the default gateway for this machine. This is done by adding the proper values to the /etc/sysconfig/network file by running the following: cat >> /etc/sysconfig/network << "EOF" GATEWAY=192.168.1.2 GATEWAY_IF=eth0 EOF The values for GATEWAY and GATEWAY_IF need to be changed to match your network setup. GATEWAY contains the IP address of the default gateway, and GATEWAY_IF contains the network interface through which the default gateway can be reached. Which interfaces are brought up and down by the network script depends on the files in the /etc/sysconfig/network-devices directory. This directory should contain files in the form of ifconfig.xyz, where xyz is a network interface name (such as eth0 or eth0:1) If you decide to rename or move this /etc/sysconfig/network-devices directory, make sure you update the /etc/sysconfig/rc file as well and update the network_devices by providing it with the new path. Now, new files are created in that directory containing the following. The following command creates a sample ifconfig.eth0 file: cat > /etc/sysconfig/network-devices/ifconfig.eth0 << "EOF" ONBOOT=yes IP=192.168.1.1 NETMASK=255.255.255.0 BROADCAST=192.168.1.255 EOF Of course, the values of those variables have to be changed in every file to match the proper setup. If the ONBOOT variable is set to yes, the network script will bring it up during the booting of the system. If set to anything else but yes, it will be ignored by the network script and thus not brought up. If you're going to be connected to the internet then most likely you'll need some means of DNS name resolution to resolve internet domain names to IP addresses. This is best achieved by placing the IP address of a DNS server into /etc/resolv.conf. Create the file by running the following: cat > /etc/resolv.conf << "EOF" # Begin /etc/resolv.conf nameserver <IP address of your nameserver> # End /etc/resolv.conf EOF Of course, replace <IP address of your nameserver> with the IP address of the DNS server most appropriate for your setup. This will often be provided by your ISP or it may even be a router on your local network.