blob: a13eb9e28f5e2d590f6ce28b107bc65f9f865c81 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
|
#include <xc.h>
// BEGIN CONFIG
#pragma config FOSC = HS // Oscillator Selection bits (HS oscillator)
#pragma config WDTE = OFF // Watchdog Timer Enable bit (WDT enabled)
#pragma config PWRTE = ON // Power-up Timer Enable bit (PWRT disabled)
#pragma config BOREN = ON // Brown-out Reset Enable bit (BOR enabled)
#pragma config LVP = OFF // Low-Voltage (Single-Supply) In-Circuit Serial Programming Enable bit (RB3 is digital I/O, HV on MCLR must be used for programming)
#pragma config CPD = OFF // Data EEPROM Memory Code Protection bit (Data EEPROM code protection off)
#pragma config WRT = OFF // Flash Program Memory Write Enable bits (Write protection off; all program memory may be written to by EECON control)
#pragma config CP = OFF // Flash Program Memory Code Protection bit (Code protection off)
// END CONFIG
// Use internal crystal at 8MHz
#define _XTAL_FREQ 20000000
//#define DEBUG 1
// Define baud rate of 9600
#define Baud_rate 9600
// Define if VFD if used
#define VFD 1
// Define ADC Option
#define ADC 1
// HD44780
#define RS RD2 // Register Select on RD2
#define EN RD3 // Enable on RD3
#define D4 RD4 // Data 4 on RD4
#define D5 RD5 // Data 5 on RD5
#define D6 RD6 // Data 6 on RD6
#define D7 RD7 // Data 7 on RD7
//Define Buttons
#define DECR RB5
#define INCR RB4
#define SETB RB2
//Define Buzz
#define BEEP RD1
|
