chapter08/fstab.xml


1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60

<?xml version="1.0" encoding="ISO-8859-1"?>
<!DOCTYPE sect1 PUBLIC "-//OASIS//DTD DocBook XML V4.3//EN" "http://www.oasis-open.org/docbook/xml/4.3/docbookx.dtd" [
  <!ENTITY % general-entities SYSTEM "../general.ent">
  %general-entities;
]>
<sect1 id="ch-bootable-fstab">
<title>Creating the /etc/fstab file</title>
<?dbhtml filename="fstab.html"?>

<indexterm zone="ch-bootable-fstab"><primary sortas="e-/etc/fstab">/etc/fstab</primary></indexterm>

<para>The <filename>/etc/fstab</filename> file is used by some programs to
determine where file systems are to be mounted by default, which
must be checked and in which order. Create a new file systems table like
this:</para>

<screen><userinput>cat &gt; /etc/fstab &lt;&lt; "EOF"</userinput>
# Begin /etc/fstab

# file system  mount-point  fs-type  options         dump  fsck-order

/dev/xxx      /            fff      defaults        1     1
/dev/yyy      swap         swap     pri=1           0     0
proc          /proc        proc     defaults        0     0
sysfs         /sys         sysfs    defaults        0     0
devpts        /dev/pts     devpts   gid=4,mode=620  0     0
shm           /dev/shm     tmpfs    defaults        0     0
# End /etc/fstab
<userinput>EOF</userinput></screen>

<para>Of course, replace <filename>xxx</filename>, <filename>yyy</filename>
and <filename>fff</filename> with the values appropriate for your system --
for example <filename>hda2</filename>, <filename>hda5</filename> and
<filename>reiserfs</filename>. For all the details on the six fields in this
table, see <command>man 5 fstab</command>.</para>

<para>When using a reiserfs partition, the <emphasis>1 1</emphasis> at the
end of the line should be replaced with <emphasis>0 0</emphasis>, as such a
partition does not need to be dumped or checked</para>

<para>The <filename>/dev/shm</filename> mount point for tmpfs is included to
allow enabling POSIX shared memory. Your kernel must have the required support
built into it for this to work -- more about this in the next section. Please
note that currently very little software actually uses POSIX shared memory.
Therefore you can consider the <filename>/dev/shm</filename> mount point
optional. For more information, see
<filename>Documentation/filesystems/tmpfs.txt</filename> in the kernel source
tree.</para>

<para>There are other lines which you may consider adding to your
<filename>fstab</filename> file. One example is a line to use if you intend to
use USB devices:</para>

<screen> usbfs         /proc/bus/usb usbfs   devgid=14,devmode=0660 0 0 </screen>

<para>This option will of course only work if you have the
"Support for Host-side USB" and "USB device filesystem"
compiled into your kernel (not as a module).</para>

</sect1>